單項選擇題A spur gear pump should be operated with the discharge valves （）.

A.slightly opened
B.throttled
C.fully opened
D.halfway opened


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題The capacity of a centrifugal pump can be increased by the installation of a larger diameter impeller Another means of increasing the pump capacity is to （）.

A.increase speed
B.increase the size of the cardent assembly
C.reduce wearing ring clearances
D.change the pump to a "close coupled" arrangement

2.單項選擇題Which of the following forms of energy is demonstrated through the process of combustion?（）

A.Chemical energy
B.Mechanical energy
C.Thermal energy
D.Electrical energy

3.單項選擇題While inspecting the steering system at sea, you should check for （）.

A.air bubbles in the sight glass
B.any leaks in the system
C.over-travel in the rudder angle indicator
D.lost motion in the rams

4.單項選擇題Excessive air leakage into the suction side of a centrifugal pump would be indicated by which of the following operational problems?（）

A.The pump delivers full capacity when started, but gradually slackens off toan abnormally low flow
B.The pump packing gland overheats after short operating periods
C.The motor over-current protective device continually shuts the pump down
D.Pounding noises can be heard at the pump suction chest

5.單項選擇題Increasing the speed of a centrifugal pump will result in an increase in its capacity Another means of increasing the capacity of a centrifugal pump is to increase the （）.

A.diameter of the discharge piping, with all other factors remaining the same
B.diameter of the suction piping, with all other factors remaining the same
C.width of the impeller only
D.diameter of the impeller

最新試題

If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.

題型：?jiǎn)雾?xiàng)選擇題

When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should （）.

題型：?jiǎn)雾?xiàng)選擇題

If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.

題型：?jiǎn)雾?xiàng)選擇題

If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will （）.

題型：?jiǎn)雾?xiàng)選擇題

A grease gun is generally used to lubricate a （）.

題型：?jiǎn)雾?xiàng)選擇題

The rate of heat transfer from a hot region to a cold region is affected most by the （）.

題型：?jiǎn)雾?xiàng)選擇題

If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.

題型：?jiǎn)雾?xiàng)選擇題

A salinity indicator is used to determine the （）.

題型：?jiǎn)雾?xiàng)選擇題

The temperature differential occurring between the inlet temperature of the fluid to be cooled and the outlet temperature of the cooling medium in a shell-and-tube heat exchanger is greatest in which of the flow designs listed?（）

題型：?jiǎn)雾?xiàng)選擇題

The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.

題型：?jiǎn)雾?xiàng)選擇題