A.Dull black appearance
B.Bright appearance
C.Thin layer of lacquer
D.Thick oily film
您可能感興趣的試卷
你可能感興趣的試題
A.noise coming from that air starting valve
B.continuous operation of the starting air compressor
C.zero air pressure in the air starting system
D.overheated starting air pipe to the cylinder head
A.stop the engine by cutting off the cooling water supply
B.stop the engine by closing the air intake
C.slow the engine but not stop it
D.slow the engine to half of normal load
A.increase the liner area covered by the oil film
B.maintain an oil film on the lower liner where scuffing is prevalent
C.keep excess oil away from intake and exhaust ports
D.help cushion piston skirt side thrust by providing a hydrodynamic oil wedge
A.the production of high pressure gases
B.the removal of expended combustion gases
C.the admission of air to the cylinder
D.all of the above
A.Speed limiting governor
B.Over-speed governor
C.Over-speed trip
D.Over-speed relay
最新試題
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a（）
The shipboard oil pollution emergency plan will be invalid after （）
Diesel engine air start system check valves are opened by （）
（）connectors hold best if a wire is accidentally pulled or a connection becomes loose.
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
Flame failure in an automatically fired auxiliary boiler can from a/an （）
Which one is NOT the ‘clear grounds’ for a more detailed inspection?（）
During the diesel engine running, the water level of F.W expansion tank should normally kept in the （） level of glass tube.