A.low exhaust back pressure
B.early fuel injection in one of the cylinders
C.compression pressure in one of the cylinders
D.plugged injector holes
您可能感興趣的試卷
你可能感興趣的試題
A.cold intake air
B.excessive compression pressure
C.excessive cylinder lubrication
D.a light load
A.grinding the spare plunger to the barrel
B.replacing the plunger and the barrel
C.highly polishing both the plunger and barrel
D.replacing plunger only
A.Control the amount of lube oil burned in the combustion chamber
B.Transmit heat from the piston to the cylinder liner
C.Prevent damage to ring groove inserts by acting as a heat dam
D.Dissipate combustion chamber gas pressure by channeling it through the ring gap
A.transfer heat from the cylinder to the piston
B.scrape oil from the sides of the piston
C.seal the combustion space from the crankcases
D.prevent any piston contact with the cylinder liner
A.compression ratio of the engine
B.volume of the engine
C.relationships between pressure and volume during one stroke of the engine
D.relationships between pressure and volume during one cycle of the engine
最新試題
The main purpose of port State control is not to（）
The Port State Control officer may witness a fire drill carried out by the crew assigned to these duties on the（）
（） is not installed on the main switchboar.
The shipboard oil pollution emergency plan will be invalid after （）
The additional mark （）in the Classification Certificate for Machinery means propulsion apparatus is remotely controlled on the navigating bridge control station, and engine assembly control station is unmanned periodically.
If separating effect is not good, which measure should be taken （）
The condensers located in various stages of a flash evaporator are cooled by（）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish