單項選擇題When running a large, low-speed, main propulsion diesel engine on heavy fuel, which of the following precautions should be observed when switching back over to diesel oil?()

A.The diesel oil must never be allowed to mix with the heavy fuel
B.The temperature of the fuel from the pre–heater should be gradually reduced after switching over the three–way valve
C.The heating steam to the pre-heater should be secured as soon as the diesel fuel passes through the three-way valve
D.The heating steam must be secured before the diesel oil passes through the three-way valve


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題Before shutting off the fuel supply to stop a medium or high–speed diesel engine, why is it necessary to allow the engine to idle for a few minutes?()

A.To prevent internal damage form local overheating
B.To ensure the fuel nozzles are flushed clean
C.To clear the smoke stack
D.To let the waste heat boiler reduce its rate of steam generation

2.單項選擇題Clogged diesel engine fuel oil filters can cause()

A.loss of power
B.misfiring
C.low fuel oil pressure
D.All of the above

3.單項選擇題If a single cylinder relief valve on a main propulsion diesel engine begins to lift, but it is not possible to secure the engine, which of the following actions should be taken?()

A.Increase the cooling water flow to the engine
B.Secure or reduce fuel to that cylinder
C.Screw down on the pressure adjusting spring to decrease to decrease popping pressure
D.Readjust the injection timing

4.單項選擇題Which of the following statements concerning fuel atomization in a diesel engine cylinder is correct?()

A.The greater the atomization, the greater the penetration
B.The greater the atomization, the less the penetration
C.The degree of atomization has nothing to do with the degree of penetration
D.Atomization and penetration are one and the same

5.單項選擇題If a tow-stroke/diesel engine is over-speeding due to leakage of lube oil into the cylinders, what should you do to stop the engine?()

A.Move the fuel control mechanism to the no fuel position
B.Block the fuel supply by closing the master fuel valve
C.Shut off the fuel supply and block the flow of intake air
D.Relieve all pressure in the fuel system

最新試題

For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?()

題型:?jiǎn)雾?xiàng)選擇題

By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()

題型:?jiǎn)雾?xiàng)選擇題

The treatment of the fuel oils involves storage, heating, filtering and()

題型:?jiǎn)雾?xiàng)選擇題

When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish

題型:?jiǎn)雾?xiàng)選擇題

Which of the listed governor characteristics will greatly affect the load sharing relationship between paralleled diesel generators?()

題型:?jiǎn)雾?xiàng)選擇題

To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()

題型:?jiǎn)雾?xiàng)選擇題

The condensers located in various stages of a flash evaporator are cooled by()

題型:?jiǎn)雾?xiàng)選擇題

Using a file without a handle may result in ()

題型:?jiǎn)雾?xiàng)選擇題

The main purpose of port State control is not to()

題型:?jiǎn)雾?xiàng)選擇題

The cetane rating of diesel fuel is an indication of the ()

題型:?jiǎn)雾?xiàng)選擇題