A.Exhaust energy would draw excess air
B.The inertia of the turbocharger rotor causes a time lag which delays the turbocharger speed increase
C.Exhaust gas pumping losses are increased due to turbine windage
D.Exhaust gas back pressure falls slightly due to increased nozzle action
您可能感興趣的試卷
你可能感興趣的試題
A.use of low viscosity oil in cold weather
B.increased moisture content of inlet air in cold weather
C.increased drag of pistons and bearings due to increased oil viscosity
D.higher compression pressures reached due to smaller clearances existing in the engine during cold weather
A.octane number
B.cetane number
C.viscosity in Saybolt seconds
D.air fuel ratio
A.Decreasing scavenge air pressure
B.Increasing exhaust temperatures before the turbine
C.Reduction in engine speed
D.All of the above
A.quality of air filtration
B.effectiveness of lubrication
C.type of fuel used
D.all of the above
A.cetane number
B.octane number
C.ignition index number
D.volatility point
最新試題
（）are used to digest the sewage to produce innocuous sludge in a biological sewage treatment plant.
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）
During the diesel engine running, the water level of F.W expansion tank should normally kept in the （） level of glass tube.
（）connectors hold best if a wire is accidentally pulled or a connection becomes loose.
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
Which of the following items don’t belong to dock repair works?（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
The condensers located in various stages of a flash evaporator are cooled by（）
Using a file without a handle may result in （）