A.ignition quality of the fuel
B.calorific value of the fuel
C.flash point of the fuel
D.rate of fuel consumption
您可能感興趣的試卷
你可能感興趣的試題
A.Viscosity
B.acid content
C.heating value
D.ignition quality
A.Viscosity
B.Sulfur content
C.Pour point
D.Cetane number
A.Exhaust energy would draw excess air
B.The inertia of the turbocharger rotor causes a time lag which delays the turbocharger speed increase
C.Exhaust gas pumping losses are increased due to turbine windage
D.Exhaust gas back pressure falls slightly due to increased nozzle action
A.use of low viscosity oil in cold weather
B.increased moisture content of inlet air in cold weather
C.increased drag of pistons and bearings due to increased oil viscosity
D.higher compression pressures reached due to smaller clearances existing in the engine during cold weather
A.octane number
B.cetane number
C.viscosity in Saybolt seconds
D.air fuel ratio
最新試題
If separating effect is not good, which measure should be taken （）
（）connectors hold best if a wire is accidentally pulled or a connection becomes loose.
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a（）
During the diesel engine running, the water level of F.W expansion tank should normally kept in the （） level of glass tube.
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
The shipboard oil pollution emergency plan will be invalid after （）
Using a file without a handle may result in （）
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
Which of the listed governor characteristics will greatly affect the load sharing relationship between paralleled diesel generators?（）