A.Hard alloy steel construction
B.Beveled edges on the valve head
C.Low alloy steel construction
D.Poppet type design
您可能感興趣的試卷
你可能感興趣的試題
A.a leaking seal ring
B.heat transfer from exhaust valves
C.restricted cooling passages
D.overheated intake valves
A.top of the ring groove
B.back of the ring groove
C.bottom of the ring groove
D.piston ring end clearance
A.oil rings only
B.compression and scraper rings
C.cylinder liner sealings
D.cylinder liner ring grooves
A.wrist pin bushings
B.compression rings
C.cylinder liner seals
D.cylinder liner sealing ring
A.Gasoline
B.Water
C.Lubricating oil
D.sulphur compounds
最新試題
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to （）
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
To proceed to the assistance of a ship in distress is（）
（） is not installed on the main switchboar.
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
Diesel engine air start system check valves are opened by （）
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?（）
The Port State Control officer may witness a fire drill carried out by the crew assigned to these duties on the（）
Flame failure in an automatically fired auxiliary boiler can from a/an （）