A.alternation of side thrust
B.a breakdown of the lube oil film on the cylinder wall
C.worn piston boss piston pin bearings
D.fluctuating gas pressure in the combustion space
您可能感興趣的試卷
你可能感興趣的試題
A.hard starting
B.excessive fuel consumption
C.loss of power
D.all of the above
A.provide added wear protection against today’s corrosive quality of fuel
B.increase overall valve strength due to the high gas pressures
C.assist in dissipating heat due to the extreme operating temperatures
D.reduce the overall weight of the valve thus helping eliminate valve spring surge and hammering
A.Excessive piston to liner clearance
B.The underside of the piston crown being excessively dirty lowering the rate of heat transfer
C.Faulty nozzle spray
D.All of the above
A.improve skirt lubrication
B.allow for expansion
C.transmit forces evenly
D.improve the piston seal
A.Hard alloy steel construction
B.Beveled edges on the valve head
C.Low alloy steel construction
D.Poppet type design
最新試題
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）
The treatment of the fuel oils involves storage, heating, filtering and（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
The main purpose of port State control is not to（）
Which one is NOT the ‘clear grounds’ for a more detailed inspection?（）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?（）