A.low ignition quality
B.a high volatility
C.low ignition delay
D.a high cetane number
您可能感興趣的試卷
你可能感興趣的試題
A.inoperative turbocharger
B.inadequate fuel supply
C.overload on one cylinder
D.unequal load distribution
A.governor sensitivity
B.exhaust temperature
C.fuel injection pressure
D.speed of the can shaft
A.low air charge temperature
B.high cranking speed
C.excessive fuel dilution of lube oil
D.high compression pressure
A.fuel lines
B.lube oil filter
C.crank case pump
D.rocker arm reservoir
A.turn engine with jacking gear
B.drain filters and strainers and bleed off water at each injection pump
C.use ether to start the engine with blow-down valves open
D.blow through the cylinders and fuel lines with a drying agent
最新試題
The ISPS Code consists of a mandatory section-Part A, which shows（）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?（）
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the（）
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to （）
（） is not installed on the main switchboar.
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
The additional mark （）in the Classification Certificate for Machinery means propulsion apparatus is remotely controlled on the navigating bridge control station, and engine assembly control station is unmanned periodically.
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）