A.decreased
B.increased
C.fixed
D.closed
您可能感興趣的試卷
你可能感興趣的試題
A.the bearing near to the diesel engine
B.the intermediate bearing near to the thrust bearing
C.the intermediate bearing near to the sterntube
D.the bearing located at the middle of the diesel engine and the sterntube
In the shafting management () should be paid more attention.
Ⅰ.f the while metal tailshaft bearing is dripping oil
Ⅱ.f some area become blue during the running
Ⅲ.he deformation of crankshaft
A.Ⅰ
B.Ⅱ
C.Ⅲ
D.Ⅱ+Ⅲ
A.the rotate speed fluctuation
B.the ventilation tube clogged
C.the main engine accelerate so fast
D.stormy waves
A.dropping lube oil for lubrication, reducing the pollution to the sea
B.setting a temporary gravity oil tank and enhanced the position properly
C.lubricating with the used lube oil
D.lubricating with the fresh water and navigation in a lower speed
A.adjusting the position of the intermediate bearing
B.changing the position of the main engine installation
C.adjusting the center line of the propeller
D.changing the position of the thrust block
最新試題
The main purpose of port State control is not to()
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?()
The treatment of the fuel oils involves storage, heating, filtering and()
The ISPS Code consists of a mandatory section-Part A, which shows()
To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()
Which of the listed governor characteristics will greatly affect the load sharing relationship between paralleled diesel generators?()
To proceed to the assistance of a ship in distress is()
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()
The additional mark ()in the Classification Certificate for Machinery means propulsion apparatus is remotely controlled on the navigating bridge control station, and engine assembly control station is unmanned periodically.
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()