A.flushing separator with hot water
B.increasing water supply flow
C.heat oily water properly
D.opening manual oil discharge value
您可能感興趣的試卷
你可能感興趣的試題
A.the separator is overload
B.the monitor equipment of separator fails
C.the discharge pump of separator can not work
D.the temperature of oil water is low
A.15；inlet value
B.15；inlet and outlet value
C.30；inlet value
D.30；inlet and outlet value
A.filled with bilge water
B.filled with oil
C.filled with clean water
D.be emptied
A.the sensor of low oil level is fully covered by sludge
B.the coarse strainer before the pump in suction system is clogged
C.the screw pump is worn seriously and volumetric efficiency is decreased
D.bilge suction value is clogged
A.the filter is clogged
B.bilge suction value is clogged
C.suction value and discharge value of the pump do not open fully
D.screw pump is worn seriously and volumetric efficiency is decreased
最新試題
The main purpose of port State control is not to（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
Diesel engine air start system check valves are opened by （）
The ISPS Code consists of a mandatory section-Part A, which shows（）
The cetane rating of diesel fuel is an indication of the （）
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）
To proceed to the assistance of a ship in distress is（）
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?（）
If separating effect is not good, which measure should be taken （）