A.10Mbps
B.11Mbps
C.54Mbps
D.100Mbps
您可能感興趣的試卷
你可能感興趣的試題
A.The port is experiencing errors.
B.The port is administratively disabled.
C.The port is blocked by spanning tree.
D.The port has an active link with normal traffic activity.
A.127.0.0.1
B.172.16.0.1
C.192.168.0.5
D.223.0.0.1
E.224.0.0.5
F.254.255.255.255
In order to allow the establishment of a Telnet session with a router, which set of commands must be configured?（）
A.A
B.B
C.C
D.D
E.E
F.F
A.the session layer
B.the protocol layer
C.the data link layer
D.the access layer
E.the network layer
F.the application layer
A.amount of RAM
B.bridge priority
C.IOS version
D.IP address
E.MAC address
F.speed of the links
最新試題
Which command displays the CHAP authentication process as it occurs between two routers?（）
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?（）
An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?（）
Three access ports have been installed and configured to a small office.What term defines the wireless topology?（）
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?（）
Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?（）
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?（）
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?（）
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?（）