A.A CSU/DSU terminates a digital local loop.
B.A modem terminates a digital local loop.
C.A CSU/DSU terminates an analog local loop.
D.A modem terminates an analog local loop.
E.A router is commonly considered a DTE device.
F.A router is commonly considered a DCE device.
您可能感興趣的試卷
你可能感興趣的試題
A.Switches are primarily software based while bridges are hardware based.
B.Both bridges and switches forward Layer 2 broadcasts.
C.Bridges are frequently faster than switches.
D.Switches have a higher number of ports than most bridges.
E.Bridges define broadcast domains while switches define collision domains.
F.Both bridges and switches make forwarding decisions based on Layer 2 addresses.
A.addresses chosen by a company to communicate with the Internet
B.addresses that cannot be routed through the public Internet
C.addresses that can be routed through the public Internet
D.a scheme to conserve public addresses
E.addresses licensed to enterprises or ISPs by an Internet registry organization
A.during high traffic periods
B.after broken links are re-established
C.when upper-layer protocols require high reliability
D.in an improperly implemented redundant topology
E.when a dual ring topology is in use
A.TFTP server, Flash, NVRAM
B.ROM, NVRAM, TFTP server
C.NVRAM, TFTP server, ROM
D.Flash, TFTP server, ROM
E.Flash, NVRAM, ROM
A.Filtering can occur based on Layer 3 information.
B.Broadcasts are eliminated.
C.Routers generally cost less than switches.
D.Broadcasts are not forwarded across the router.
E.Adding a router to the network decreases latency.
最新試題
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?（）
Which pairing reflects a correct protocol-and-metric relationship?（）
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?（）
At which layer of the OSI model is RSTP used to prevent loops?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?（）
A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?（）
What is the purpose of the cisco Vlan Trunking protocol?（）
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?（）