A.neighbor table
B.SPF table
C.RTP table
D.topology table
E.query table
F.DUAL table
您可能感興趣的試卷
你可能感興趣的試題
A.1024
B.2046
C.4094
D.4096
E.8190
A.assigning a private IP address to the AP
B.changing the default SSID value
C.configuring a new administrator password
D.changing the mixed mode setting to single mode
E.configuring traffic filtering
A.The switch will not forward unicast frames.
B.The switch will forward the frame to a specific port.
C.The switch will return a copy of the frame out the source port.
D.The switch will remove the destination MAC from the switch table.
E.The switch will forward the frame to all ports except the port on which it was received.
A.can be used over analog circuits
B.maps Layer 2 to Layer 3 address
C.encapsulates several routed protocols
D.supports IP only
E.provides error correction
A.default gateway
B.DNS servers
C.FTP server
D.helper address
E.subnet mask
F.TFTP server
最新試題
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?（）
What is the default administrative distance of OSPF?（）
Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
Which command encrypts all plaintext passwords?（）
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?（）
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）
Which pairing reflects a correct protocol-and-metric relationship?（）