A. you can apply multiple access lists with the same protocol or in different direction.
B. you can config one access list,per direction,per layer 3 protocol
C. you can place as many access lists as you want on any interface
D. you can apply only one access list on any interface
您可能感興趣的試卷
你可能感興趣的試題
A. spanning-tree mode rapid-pvst
B. spanning-tree uplinkfast
C. spanning-tree backbonefast
D. spanning-tree mode mst
A. they run a spell check on host names to ensure accurate routing
B. they map individual hosts to their specific IP address
C. they convert domain names into IP address
D. Given an IP address,they determine the name of the host that is…
A. Flash,TFTP server,ROM
B. Flash,NVRAM,ROM
C. ROM,NVRAM,TFTP server
D. NVRAM,TFTP server,ROM
E. TFTP server,Flash,NVRAM
A. show session
B. show cdp neighbors
C. show users
D. show queue
A. transport type all
B. transport output all
C. transport preferred all
D. transport input all
最新試題
Which pairing reflects a correct protocol-and-metric relationship?（）
Which statement describes the rule of split horizon?（）
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?（）
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）
Which command encrypts all plaintext passwords?（）
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?（）
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?（）