單項選擇題

A router has two paths to reach another network in a different autonomous system. Neither route was generated by the local router and both routes have the same default weight an d local preference values.
Which statement is true about how BGP would select the best path?()

A. To influence one route to be preferred, its default local preference value will be changed via the use of the command bgp default local - preference 50
B. Th e router will prefer the shortest autonomous system path
C. If the command bgp always - compare - med has been given, then the router will prefer the route with the highest MED
D. The router will prefer the route with the lower MED


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題

Refer to the exhibit. Which two statement s are correct?()

A. All the routes were redistributed into BGP from an IGP
B. All the routes were originated by BGP with the network command
C. All six routes will be installed in the routing table
D. Four routes will be installed in the routing ta ble
E. Two routes will be installed in the routing table

2.多項選擇題

Refer to the exhibit. Which two statements are true about the partial configuration that is provided.()

A. The peer group shortens the EBGP configuration
B. The peer group shortens the IBGP configuration
C. All the configured neighbors are in autonomous system 100
D. Three AS - path filters are applied to each BGP neighbor
E. Only the outgoing filters are applied to BGP updates

3.單項選擇題Which of the following is an OSPF configuration parameter that is used on an ABR, but not on an internal router?()

A. A virtual link to area 0.
B. OSPF summarization command.
C. default - cost extension to the area command.
D. no - summary extension to the area stub comm and.
E. None of the other alternatives apply

4.多項選擇題An etwork administrator has enabled OSPF across an NBMA network and has issued the command ip ospf network nonbroadcast. Given those facts, which two statements are true?()

A. Interfaces will automatically detect and build adjacencies with neighbor routers
B. DR and BDR elections will not occur
C. DR and BDR elections will occur
D. The neighbor command is required to build adjacencies
E. All routers must be configured in a fully meshed topology with all other routers

5.單項選擇題According to RFC 2328, what is the stateful order in which an OSPF router transitions to a full adjacency with a neighbor router?()

A. Down, Init, 2 - Way, Exstart, Exchange, Loading, and Full
B. Down, Init, 2 - Wa y, Exchange, Exstart, Loading, and Full
C. Down, 2 - Way, Init, Loading, Exstart, Exchange, and Full
D. Down, 2 - Way, Init, Exchange, Exstart, Loading, and Full
E. Down, Init, 2 - Way, Loading, Exstart, Exchange, and Full
F. Down, 2 - Way, Init, Exstart, Exch ange, Loading, and Full

最新試題

Look at the following configuration below and select the statements that are true.()RD2(config)#router ospf 100RD2(config - router)# distance 180 10.1.10.1 0.0.0.0 match - meRD2(config -router)#!RD2(config - router) #ip access - list standard match - meRD2(config - std - nacl)# permit host 172.16.0.0

題型:多項選擇題

Which of the following features work the same in both RIP- 2 and RIPng?()

題型:多項選擇題

An engineer is trying to summarize the following networks using the "ip summary- address eigrp"command:10.8.88.0/2510.8.89.48/2910.8.64.96/27Which network and subnet mask below would be the smallest EIGRP summary address to include all three subnets?()

題型:?jiǎn)雾?xiàng)選擇題

Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exists in a planning document, intended to be used to copy/paste into Router R1 to enable OSPFv3 on interfaces F0/0 and S0/0/0. No other related configuration exists. Assuming F0/0 and S0/0/0 reach an up/up state, which of the following is true about OSPFv3 on R1 after this configuration has been pasted into R1?()ipv6 router ospf 1ipv6 unicast- routinginterface f0/0ipv6 address 2000 ::1/64ipv6 ospf 1 area 1interface s0/0/0ipv6 address 2001::/64 eui - 64ipv6 ospf 1 area 0

題型:?jiǎn)雾?xiàng)選擇題

Router R1, a branch router, connects to the Internet using DSL. The engineer plans to use a configuration with a dialer interface. The answers list a feature and interface on which the feature could be configured.Which combinations accurately describe the interface under which a feature will be configured?()

題型:?jiǎn)雾?xiàng)選擇題

An Enterprise rou ter, Ent1, displays the following excerpt from the show ip bgp command. ENT1 has an eBGP connection to an ISP router with address 3.3.3.3 and an iBGP connection to a router with address 4.4.4.4. Which of the following is most likely to be true?()Network  Next Hop Metric LocPrf Weight Path*> 3.3.3.3 0 0 1 1 1 1 218 i

題型:?jiǎn)雾?xiàng)選擇題

An enterprise h as plans to start adding IPv6 support. For the first year, the IPv6 will be in small pockets spread around the existing large IPv4 network, with occasional IPv6 traffic while applications teams test IPv6 - enabled servers and applications.Which of the fol lowing tools would be most appropriate?()

題型:?jiǎn)雾?xiàng)選擇題

Which of the following is the shortest valid abbreviation for FE80:0000:0000:0000:0010:0000:0000:0123?()

題型:?jiǎn)雾?xiàng)選擇題

Which of the following answers lists either a protocol or function that can be used by a host to dynamically learn its own IPv6 address?()

題型:多項選擇題

The answers each list a tunnel method and two consecutive IPv6 address quartets.Which answers identify a tunneling method that relies on an IPv4 address to be embedded into an IPv6 address, within the correct quartets listed?()

題型:多項選擇題