A.Liquids with different viscosities will always have the same specific gravity
B.Liquids with different viscosities will never have the same specific gravity
C.Viscosity and specific gravity are directly proportional
D.Viscosity and specific gravity are not related in that one does not define or limit the other
您可能感興趣的試卷
你可能感興趣的試題
A.stored at temperatures below 60 degrees Fahrenheit
B.charged into a system having copper fittings
C.allowed to mix with compressor oil
D.exposed to an open flame or hot surface
A.acid formation
B.sludge formation
C.ice in the expansion valve
D.All of the above
A.superheated outside the system
B.in contact with an open flame
C.heated to the boiling point
D.All of the above
A.Variable volumes can be obtained with gear pumps only by variation of the pump drive speed
B.A radial piston pump houses sliding pistons in a stationary cylinder block through which passes a rotating pintle or ported shaft
C.The amount of fluid displaced per revolution of an axial piston rotary pump is dependent on the angle formed between the cylinder block and valve plate
D.All of the above
A.transmit the rudder angle to the bridge indicator
B.prevent the control linkage from striking the stops when hard over
C.automatically purge all entrained air from the system
D.send hydraulic signals to the receiving unit
最新試題
An internal bypass is provided on some hydraulic system suction strainers to help reduce the possibility of （）.
Thermostatic expansion valves can be adjusted for （）.
When the steering gear is in operation, you should （）.
The output volume of a positive fixed displacement pump can be changed only by （）.
On tank vessels equipped with power operated cargo tank valves, the type of power operator most commonly used is （）.
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by （）.
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by （）.
Which of the listed pumps is NOT a positive displacement pump?（）
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?（）