A.worn bearings and piston pins
B.slugging due to flooding back
C.too much oil in circulation
D.All of the above
您可能感興趣的試卷
你可能感興趣的試題
A.superheated
B.super-cooled
C.at or below the dew point
D.All of the above
A.open the steam line mot valve
B.drain the steam cylinder
C.close the steam cylinder drains
D.open the liquid cylinder drains
A.rudder will respond sluggishly
B.hydraulic rams will over-speed
C.sight glass will show bubbles
D.ram relief valves will lift
A.continuous running of the compressor
B.high suction pressure
C.high discharge pressure
D.short cycling of the compressor on the water failure switch
A.the cooling effect of the condensate reduces the compressors efficiency
B.a danger of explosion exists whenever water is present in a compressor
C.water causes erratic operation of pneumatic components
D.the volumetric capacity of the first stage is reduced if water remains
最新試題
When the steering gear is in operation, you should （）.
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?（）
An excessive charge of refrigerant in an air-cooled refrigeration system can cause （）.
Which of the listed pumps is NOT a positive displacement pump?（）
If the viscosity of the liquid being transferred remains constant as the discharge pressure increases, the rotary pump （）.
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.
The control mode in which the final control element is moved from one of two flexed positions to the other is known as （）.
Which of the following statements is correct concerning heat transfer?（）
The rate of heat transfer from a hot region to a cold region is affected most by the （）.