A.dispersant additives
B.floc point
C.alkalinity additives
D.ignition quality
您可能感興趣的試卷
你可能感興趣的試題
A.starting the engine hot
B.knurling the piston skirt
C.operating an overheated engine
D.using scuff resistant piston rings
A.the amount of lube oil additives increase
B.piston speeds increase
C.injection pressure decrease
D.engine speeds decrease
A.less piston slap and quieter running
B.increased crankshaft bearing wear
C.slightly greater piston wear
D.decreased side pressures
A.Liner wear is distributed equally between the upper and lower portions of the cylinder
B.Excessive liner wear causes wear between piston ring and groove
C.Excessive, but uniform liner wear will not cause wear between piston ring and groove
D.Liner wear is normally greatest in the middle of the cylinder
A.alternation of side thrust
B.a breakdown of the lube oil film on the cylinder wall
C.worn piston boss piston pin bearings
D.fluctuating gas pressure in the combustion space
最新試題
Under MARPOL Code the ship to which it applies has to carry （）
Which one is NOT the ‘clear grounds’ for a more detailed inspection?（）
Which of the following items don’t belong to dock repair works?（）
（）are used to digest the sewage to produce innocuous sludge in a biological sewage treatment plant.
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a（）
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）
The Port State Control officer may witness a fire drill carried out by the crew assigned to these duties on the（）
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）