A VTP domain has six active VLANs. Without notice， all VLANs except VLAN1 fail. Just prior tothe failure， Switch2 was added to the network.
Which three issues on Switch2 could be the cause？（）
A.Switch2 is configured for only VLAN1
B.Switch2 is a VTP server in a different domain
C.Switch2 is a VTP server in the Company domain
D.Switch2 is not a VTP domain.
E.Switch2 has a lower VTP configuration revision number than the current VTP revision
F.Switch2 has a higher VTP configuration revision number than the current VTP revision
您可能感興趣的試卷
你可能感興趣的試題
A.Physical management of the switch
B.Logical management of the switch
C.In-band management of the switch
D.Out-of-band management of the switch
A.Reload the active VLAN configuration
B.Clear the affected port and bring it up again
C.Explicitly set the trunk for the VLAN to be on
D.Remove all the VLANs set
A.The link is using IEEE 802.1Q protocol
B.The link is using IEEE 802.1E protocol
C.Spanning tree is disabled
D.Not enough information to determine
E.The native VLAN information is identical at each end of the link
F.The native VLAN information is different at each end of the link
A.IEEE 802.1Q
B.IEEE 802.10
C.Misconfigured NIC
D.User configuration
E.All of the above
A.SW13 has a higher VTP configuration revision than the current VTP revision
B.SW13 is configured as a VTP server with a different domain name
C.SW13 is configured as a VTP server with the domain name R1
D.SW13 has a lower VTP configuration revision than the current VTP revision
E.SW13 is not configured to participate in VTP
F.SW13 is configured with only VLAN1
最新試題
As a network technician， do you know what is a recommended practice for secure configurationmanagement？（）
A new router was configured with the following commands：The configuration above was found on an Internet Service Provider’s （ISP） Multiprotocol LabelSwitching （MPLS） network. What is its purpose？（）
Network Topology Exhibit：Configuration Exhibit：NET（config）# access-list 112 deny icmp any any echo logNET（config）# access-list 112 deny imp any any redirect logNET（config）# access-list 112 deny icmp any any mask-request logNET（config）# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET（config）# interface Fa0/1NET（config-if）# ip access-group 112 inYou work as a network administrator at networkTut.com， study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However， the configurationis incorrect. On the basis of the information in the exhibit， which configuration option wouldcorrectly configure router NET？（）
Which statement about PPPoA configuration is correct？（）
Drag and drop the steps in the process for provisioning a cable modem to connect to a headendon the above to the below in the order defined by the DOCSIS standard.
As a network engineer， do you know for what purpose SDM uses Security Device Event Exchange（SDEE）？（）
Study this exhibit carefully. What information can be derived from the SDM firewall configurationdisplayed？（）
Authentication is the process of determining if a user or identity is who they claim to be. Refer tothe exhibit. Which statement about the authentication process is correct？（）
Drag and drop each function on the above to the hybrid fiber-coaxial architecture component that itdescribes on the below.
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）